Keenovo Custom Designed and Manufactured Silicone Heater for Creality K2 Plus 3D Printer

Keenovo Custom Designed and Manufactured Silicone Heater for Creality K2 Plus 3D PrinterDescription: This listing is for a custom Keenovo Silicone Heater with the following specifications said to be for a Creality K2 Plus: Size: 353mm x 356mm Power: 800W Accessories: 1m power wires, exit from center of the short side Surface mount NTC thermistor with 1m extension wire(offered for free) Lohmann adhesive backing Pre made holes cutouts as per drawing Please kindly check the heater drawing on this listing and make sure the pad size and hole

Description:

• This listing is for a custom Keenovo Silicone Heater with the following specifications said to be for a Creality K2 Plus:
• Size: 353mm x 356mm
• Power: 800W
• Accessories:
• 1m power wires, exit from center of the short side
• Surface mount NTC thermistor with 1m extension wire(offered for free)
• Lohmann adhesive backing
• Pre-made holes/cutouts as per drawing
• Please kindly check the heater drawing on this listing and make sure the pad size and hole positions fit your build plate before placing the order.

Important Notes:

• Heaters may get super hot. Please handle with care.
• A supporting frame/layer is strongly suggested to have the heating element "sandwiched" tightly for better heating result.
• If your heater comes with Keenovo Digital Controller, please read the Controller Configuration Manual, especially the "Advanced Setting" part, carefully BEFORE making any changes on the controller.
• The controller unit is 100% brand new. Yet due to manufacturing reasons, stains, dusts or scratches may be present on the silicone case. It may also fit less tight as shown in the picture. Please consider this before the purchase.
• If you heater comes with a builtin thermostat, please kindly note that the thermostat, being mechanical (bi-metal and snap action), should not be considered as a precise temperature control device, but as an auto-regulating and over-heating protection device. Its action temperatures may be subjected to certain tolerances or hysteresis due to factors such as heater power rating, ambient temperatures and heat consumption/loss rate etc.
• As we receive customer feedback, we do make small alterations to our products if we feel they improve the their performance and stability. The item(s) you receive might reflect some of these slight changes and improvements.
• Do not cut the heater.