Shake well before use.

Get ready with 3 pieces of a brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)

When first applying AUTOTRIZ 3D Matrix Hybrid Coating on a substrate, it is recommended to condition the surface of the applicator block with 7-8 drops to prevent skipping or dry spots.

Do not work on a large area at a time. It is recommended to do a 2 ft. x 2 ft. area at a time.

Apply AUTOTRIZ 3D Matrix Hybrid Coating using normal pressure on the applicator. Make sure the area is well covered. Always start from an edge to avoid excess on other panels. Work in controlled areas to remember where you previously applied. Work in horizontal or vertical movements to ensure that product is carried through consistently.

Wait for 1-2 minutes. Use the first towel to level the product.

Go immediately over with a second microfiber towel with a polishing motion until the surface is free from residue.

Follow by the third towel (this is called the “insurance towel”) and go over the surface one extra time just to make sure you haven’t missed any streaks or excess residue just to make sure you haven’t missed any streaks or excess residue.

When the whole car is applied, allow the curing of the coating to begin. Wait approximately 30-60 minutes before applying a second layer. For the ultimate in hydrophobic results and durability, it can be over-coated with AUTOTRIZ Top Coat.

Curing times depend on temperature and humidity. Applying too early and the product will dissolve the previous layer. Allow curing of coating to begin. Curing can be accelerated using IR Lamps. Follow the lamp manufacturer's recommended settings.

Keep coating away from all polish and compound dust during the curing process.

INSPECTION LIGHTING SYSTEM

Lighting is of utmost importance during the application of a coating to paint. Spot Light like Scangrip is a good lighting system to inspect paint defects during polishing but in fact, it is NOT RECOMMENDED to use to check the residue of coating left on the paint. The suitable lighting system is Diffused Light.